SILAFIX FS-200 ULTRA in a tube

Name: SILAFIX FS-200 ULTRA in a tube
Brand: SILAFIX

Transparent rubber-based adhesive for small installation and repair jobs. Squeeze directly from the tube without a caulking gun. Suitable for interior and exterior use.

Transparent80 ml tube

RubberBase

200 kg/m²Initial grab

Initial grab time: 1–10 minutes
Recommended bonding temperature: +15 to +30 °C
Full cure: 48 hours

Ask about the product Open the instructions

Properties and documents

For mounting and renovation

WoodGlassMetalCeramicsStoneDuropolymerRigid PVCABSPolycarbonate

SILAFIX FS-200 ULTRA is used to install slats, skirting boards, trims, panels, tiles and kitchen splashbacks. It bonds wood and wood-based materials, glass, metal, ceramics, marble, granite, concrete, brick and cork. Suitable for duropolymer and rigid plastics including PVC, ABS and polycarbonate.

Once cured, the joint is strong, flexible and transparent. The formulation contains solvent: test compatibility with the specific plastic or coating on a small area first. Support heavy parts while the adhesive cures.

Initial grab in 1–10 minutes
Transparent, flexible joint
For interior and exterior use
Contains no isocyanates, benzene, toluene or water

Properties

Key facts about the formulation and packaging.

Base	Synthetic rubber with solvent
Colour	Transparent
Initial grab strength	200 kg/m²
Initial grab time	1–10 minutes
Wait before pressing again	30 seconds to 1.5 minutes
Recommended bonding temperature	+15 to +30 °C
Cured joint service temperature	−20 to +60 °C
Full cure	48 hours
Consumption	150–300 g/m²
Shelf life	18 months
Packaging	80 ml tube

Coverage: 150–300 g/m², depending on the substrate and application method. Initial grab does not mean the joint is ready to bear a load.

Packaging

Packaging images for catalogues and print.

SILAFIX FS-200 ULTRA in an 80 ml tube — 80 ml tube

Application guidance

Open the instructions

Prepare the substrates

Clean, degrease and dry both surfaces. Recommended bonding temperature: +15 to +30 °C. Check material compatibility.

Apply and join

Apply in zigzags, dots or a grid. Immediately join the parts, slide them slightly against one another, then separate them.

Wait and press

Wait 30 seconds to 1.5 minutes, rejoin the parts and press firmly. Initial grab takes 1–10 minutes; full cure takes 48 hours. Temporarily support heavy parts.

Material restrictions

Not suitable for polyethylene, polypropylene, expanded polystyrene or flexible polyurethane foam. For mirrors, choose an adhesive compatible with their protective backing.

Contains solvent

Contains solvent. Flammable. Work with ventilation, away from flames, sparks and heaters. Do not smoke. Wear gloves and keep out of reach of children. Follow the safety instructions on the specific packaging label.